Porcelain and Enamel Polishing Kit CA

Product Description

This kit is designed for finishing and polishing porcelain and enamel restorations. The kit includes Ceramisté Standard, Ultra, and Ultra ll (only in Midi-Pt. & Cup) in (5) Midi-Pt., (3) Cup, (2) Wheel, and Dura-White (1) FL2, (1) RD2. INTENDED PURPOSE Ceramisté Standard: Pre-polishing Ceramisté Ultra: Polishing Ceramisté Ultra ll: Super-polishing Dura-White: Fine contouring and finishing PRECAUTIONS AND WARNINGS • Never exceed the maximum permissible rotating speed. Ceramisté Required Speed 10,000-20,000 rpm Dura-White Required Speed 5,000-30,000 rpm • Operate at recommended pressure only. • Insert the shank completely into the chuck of the hand piece, following the manufacturer’s instructions. • Perform test run to check safety and smooth operation without run-out prior to use. • Make sure that abrasive head is in good condition before use. Do not use damaged or defective instruments i.e. corrosion, surface flaw, deformation, dirt, exposure of shank due to repeated use. • Use local dust extractor, protective mask, etc while contouring and finishing to avoid adverse effect of dust to the human body. • Use protective equipment such as glasses while using. • Avoid any use at acute angles or with excessive pressure to thin and long abrasives. They are fragile and may bend or fracture under excessive loads. • This product is intended for use by dental professionals only. • Use the points for indicated purpose only. STORAGE AND STERILIZATION This kit can be sterilized in any steam or chemical autoclave. Store this product avoiding exposure to moisture, corrosive chemical and its vapor. Keep away from external pressure (physical load) and avoid contamination. When using intraorally, sterilize this product before each use. For reuse after using, remove any contaminants immediately with washer disinfector, then sterilize. Follow the instructions for use of washer disinfector and sterilizer, respectively. Chlorine disinfectant must not be used to avoid corrosion of the instruments. For the details about REPROCESSING procedures, visit www.shofu.de. DISPOSAL Dispose in accordance with relevant local and national regulation. Non-Latex

Product Details