
Composite Polishing Kit CA
Product Description
This kit is designed for finishing and polishing all types of composites without scratching the surrounding enamel. The kit includes CompoSite regular and fine in (4) Midi-Pt., (4) Cup, (2) Knife, and Dura-White (1) FL2, (1) RD2. INTENDED PURPOSE CompoSite Regular: Finishing and pre-polishing CompoSite Fine: Polishing Dura-White: Fine contouring and finishing PRECAUTIONS AND WARNINGS • Never exceed the maximum permissible rotating speed. CompoSite Required Speed 10,000-20,000 rpm Dura-White Required Speed 5,000-30,000 rpm • Operate at recommended pressure only. • Insert the shank completely into the chuck of the hand piece, following the manufacturer’s instructions. • Perform test run to check safety and smooth operation without run-out prior to use. • Make sure that abrasive head is in good condition before use. Do not use damaged or defective instruments i.e. corrosion, surface flaw, deformation, dirt, exposure of shank due to repeated use. • Use local dust extractor, protective mask, etc while contouring and finishing to avoid adverse effect of dust to the human body. • Use protective equipment such as glasses while using. • Avoid any use at acute angles or with excessive pressure to thin and long abrasives. They are fragile and may bend or fracture under excessive loads. • This product is intended for use by dental professionals only. • Use the points for indicated purpose only. STORAGE AND STERILIZATION This kit can be sterilized in any steam or chemical autoclave. Store this product avoiding exposure to moisture, corrosive chemical and its vapor. Keep away from external pressure (physical load) and avoid contamination. When using intraorally, sterilize this product before each use. For reuse after using, remove any contaminants immediately with washer disinfector, then sterilize. Follow the instructions for use of washer disinfector and sterilizer, respectively. Chlorine disinfectant must not be used to avoid corrosion of the instruments. For the details about REPROCESSING procedures, visit www.shofu.de. DISPOSAL Dispose in accordance with relevant local and national regulation. Non-Latex
Product Details
Price varies by vendor • 8 vendors (6 available)
Vendor Pricing Comparison
Compare prices from 8 vendors and add to cart
Similar Products
Products you might be interested in

Patterson® Micro Finishing Diamond Burs – Standard, 5/Pkg - Fine, 40 Microns, Pointed Taper, # 862-012-5, 1.2 mm Diameter, 5.0 mm Length

Patterson® Micro Finishing Diamond Burs – Standard, 5/Pkg - Ultra Fine, 15 Microns, Flat End Taper, # 856L-016-10, 1.6 mm Diameter, 10 mm Length

Patterson® Micro Finishing Diamond Burs – Standard, 5/Pkg - Ultra Fine, 15 Microns, Pointed Taper, # 862-012-5, 1.2 mm Diameter, 5.0 mm Length

Patterson® Carbide Burs – FG Standard, Tapered Fissure Flat End Plain - # 170, 1.0 mm Diameter, 4.1 mm Length, 100/Pkg

Patterson® Carbide Burs – FG Standard, Tapered Fissure Flat End Plain - # 169L, 0.9 mm Diameter, 5.3 mm Length, 100/Pkg
8 vendors · 6 in stock